Garage Door Opener Remote for ATA PTX4 SecuraCode, Replacement Garage Gate Door Remote 433.92MHz-1 Pack

Description
The PTX4 replacement remote control has 4 buttons, which will allow you to code this remote control into four different door or gate openers.

Specification
1.Compatibility List:
ptx-4, ptx-4 pink, tx-5
CRX-1, CRX-2
SecuraLift GDO-2v5, SecuraLift GDO-2v6, SecuraLift GDO-2v7, SecuraLift GDO-7v1, SecuraLift GDO-9v1
EasyRoller GDO-4v3, EasyRoller GDO-4v4, EasyRoller GDO-4v5, EasyRoller GDO-4v6
Ultra Slim Hard Disk EasyRoller GDO-6v1, Ultra Slim Hard Disk EasyRoller GDO-6v2
EasyRoller II GDO-8v1, EasyRoller II GDO-8v2
2.Not compatible with:B&D PTX4:
Not compatible with B&D PTX4 black case remote, PTX5 remote.
Not compatible with other GDO-9 door openers (e.g., SecuraLift GDO-9v2, Enduro GDO-9v2, Dominator GDO-9v3, and Dynamo GDO-9v3) except SecuraLift GDO-9v1.

Programming the remote control via the motor/receiver
1.Make sure the batteries are installed correctly in the new remote control.
2.Press and hold the blue door code button on the door opener motor (SW1 or SW2 button on the receiver board). Do not release the button until step 4.
3.Press the new remote control button you want to use to control the door for 2 seconds.
4.Release and pause for 2 seconds. Press the same button on the remote control again for 2 seconds.
5.Release the door code or SW button on the motor/receiver.
6.Press the button on the new remote control and test the door/gate operation.
7.To remove the remote control code from the unit, repeat steps 1-5 above.