AQUAECO Compatible MWF GE Water Filter

The AquaEco MWFAQE filter is a premium compatible filter for GE MWF SmartWater. It uses coconut carbon technology to remove chlorine, particles, impurities, dirt, rust, sand, taste, odour and lead.
Specification:

• Micron Rate: 5 Micron
• Operating Temp: 38-100
• Operating Pressure: 30-120 PSI/207-824 KPA
• Flow Rate: 0.75 GPM/2.8 LPM
• NSF Tested Service Life: 300 Gallons or 6 Months

• Removes 99% of Chlorine, particles, impurities, dirt, rust, sand, taste, odour and lead

• NSF 42 & 53

Installing the Filter Cartridge:

1. On models without a replacement indicator light, apply the month sticker to the new cartridge and mark your calendar to remind you to replace the filter after six months.
2. Remove old filter cartridge by grasping and turning to the left about 1/2 turn.
3. Remove the protective foil from the end of the new filter. Fill the replacement filter with a little water from the tap to allow for better flow immediately after installation.
4. Place the top of the new cartridge up inside the cartridge holder. Slowly turn the filter to right until the filter cartridge stops. Do not over tighten. As you turn the cartridge it will automatically raise itself into position. The cartridge will move about 1/2 turn.
5. Run water from the dispenser for 6-8 minutes (about 3-4 litres) to clear the system and prevent sputtering.
6. On models with a replacement indicator light, press and old the RESET WATER FILTER PAD on the dispenser for 3 seconds